I have a Call Manager Express 4.1 running on a Cisco 2811 router. I have an 8 port switch module in the router but I want to add more phones.
I bought a Linksys SRW2024P 24port PoE switch. On the cisco switch module, I have voice vlan 100 configured, access vlan 200. The port I am using to cascade to the Linksys switch is set up as a trunk and using vlan 200 as native.
switchport trunk native vlan 200
switchport mode trunk
switchport voice vlan 100
switchport access vlan 200
My question is, is it possible to set up the non-Cisco switch (ie. the SRW2024P) to use the voice vlan feature like in the cisco products?
I want to do this, first not to be tied to using certain ports for IP telephony only and other for data only, and also because I have some phones like the 7970 which have built in pc port in them which would need access to vlan 200.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...