05-18-2008 09:08 AM - edited 03-15-2019 10:43 AM
Hello,
Is there anyway to present more than 100 entries in Local directory of CME?
Any workaround, any ideia to overcome the limitation?
Thanks,
Met.
05-18-2008 09:51 AM
Hi Met,
Here is one alternative;
Bulk-Loading Speed Dial Numbers
There can be up to ten text files containing lists of many speed-dial numbers that are loaded into flash, slot, or TFTP locations to be accessed by phone users. The ten files can hold 10,000 numbers.
Phone users dial the following sequence:
prefix-code list-id index [extension-digits]
SCCP: Enabling Bulk-Loading Speed-Dial
To enable bulk-loading speed-dial numbers, perform the following steps:
Prerequisites
â¢Cisco Unified CME 4.0 or a later version.
â¢The bulk speed-dial text files containing the lists must be available in a location that is available to the Cisco Unified CME router: flash, slot, or TFTP location.
Restrictions
â¢Bulk speed dial is not supported on FXO trunk lines.
SUMMARY STEPS
1. enable
2. configure terminal
3. telephony-service
4. bulk-speed-dial list list-id location
5. bulk-speed-dial prefix prefix-code
6. end
Hope this helps!
Rob
05-18-2008 02:16 PM
Rob,
I've read in another post about this solution. But for what i understand, it loads speed dials...but how do people make searches in the list?
Thanks,
Met.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: