Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Local Directory 100 entry limit in CME

Hello,

Is there anyway to present more than 100 entries in Local directory of CME?

Any workaround, any ideia to overcome the limitation?

Thanks,

Met.

2 REPLIES
Hall of Fame Super Red

Re: Local Directory 100 entry limit in CME

Hi Met,

Here is one alternative;

Bulk-Loading Speed Dial Numbers

There can be up to ten text files containing lists of many speed-dial numbers that are loaded into flash, slot, or TFTP locations to be accessed by phone users. The ten files can hold 10,000 numbers.

Phone users dial the following sequence:

prefix-code list-id index [extension-digits]

SCCP: Enabling Bulk-Loading Speed-Dial

To enable bulk-loading speed-dial numbers, perform the following steps:

Prerequisites

•Cisco Unified CME 4.0 or a later version.

•The bulk speed-dial text files containing the lists must be available in a location that is available to the Cisco Unified CME router: flash, slot, or TFTP location.

Restrictions

•Bulk speed dial is not supported on FXO trunk lines.

SUMMARY STEPS

1. enable

2. configure terminal

3. telephony-service

4. bulk-speed-dial list list-id location

5. bulk-speed-dial prefix prefix-code

6. end

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmespeed.html#wp1010879

Hope this helps!

Rob

Community Member

Re: Local Directory 100 entry limit in CME

Rob,

I've read in another post about this solution. But for what i understand, it loads speed dials...but how do people make searches in the list?

Thanks,

Met.

385
Views
2
Helpful
2
Replies
CreatePlease to create content