When the user need make a calls, he must dial a PIN or password and then the phone be enable or unlock. If the user go out, he must dial the PIN again for lock. Only can receive calls, but not make calls, until that unlock the phone.
you can leave a DN that can only receive calls when logged out of EM on the phone. other than configuring that, you would need to look for a 3rd party app as CUCM does no have this capability you're looking for as the link you provided
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...