I would like to debug a possible intermittent SIP issue with my SIP carrier. It needs to be output to my syslog server and I don't want it to be overly verbose and I want to limit the debug to one SIP peer only. That is I would like to see in syslog all SIP response codes 2XX, 3XX, 4XX, 5XX. 6XX.
debug ccsip messages is going to give you the response codes you are looking for. However, you won't be able to limit syslog messages from one peer, it will be for the whole router. You should easily be able to grep through the syslogs for the host you are concerned with and the response codes.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...