Do you get "Your call cannot be completed as dialed" or is it a fast busy signal? If you are getting the first message, then it is do with extra/less digits being sent to telco. Usually telco doesnot like the 9 with the number so if your pattern is 9.@, you should do "strip predot" and it should let you dial successfully.
The fact you are seeing the number in the DEBUG Q931 message means you are sending the number as per the debug i.e without the 9 and your CSS are correct as far as the outbound to the GW so all good. There are normally two reason why you get a unassigned number
Inbound to CCM- The CSS of the gateway can not see the partition which called Number is in
Outbound- The Telco does not recognise the number. Is number owned by the Telco, an issue is may they have not updated their switches so do not recognise the number - is it new -I`ve had this between Telco`s in NY
Is the GW directly out to the telco or does it connect to another CCM, PABX?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...