I am having issues with a site where LD dialing is not working, message says, circuit is not configured for Long distance calls. The Telco have done tests and say it is a problem with the Gatway config, but the gateway is configured the same as several other sites on the same CM. The Telco also says that the gateway needs to be configured for "call screening, 10 digit dial, NI2 , 6963 as pic & lpic ". Can anyone explain what this means in particular the "6963 as pic & lpic" bit.
ISDN debugs below
Sep 8 14:31:26.629: ISDN Se0/0/0:23 Q931: Applying typeplan for sw-type 0x3 is 0x2 0x1, Calling num 105000
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...