Looking for Clarification: Route Lists / Route Groups
Hello Voice Experts,
We have 2 voice gateways (3825s). Each gw has 2 pri (one for local, one for ld calls) Our 800#s come in to the LD. Recently we have been reaching capacity on the LD circuits, resulting in routelistexhausted alerts, and of course our customers receive busies during this time. While mgmt is discussing longer term plans for increasing our capacity, I thought we could do a shorter term stop-gap by eliminating contention for the LD lines by routing long distance outbound calls over our local lines. I picked the 3 route patterns that use the LD route lists / route groups and just pointed them to the locals. I didn't think I would need to change anything about HOW we dial or edit the route pattern, other then pointing it somewhere else. Well, it didn't work. The calls were making it to the gateway but not completing. We got errors regarding dialing the area code, or dialing 1. I guess I don't have a clear understanding about how this works. Can anyone clarify what went wrong? Thanks in advance!
Re: Looking for Clarification: Route Lists / Route Groups
Hi Mark and thank you,
Yes, we dial 1+AREA CODE for local calls as well. That's why I figured it would work. I had to revert my changes last night, as calls were not completing, so unfortunately I can't post debugs until after hrs. Our discard digit selection is PreDot 11D->10D?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.