Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lost security pasword CUCM 5

Hi all!

somebody knows like recovery security password in a CCM 5?

Thanks!

1 REPLY
Hall of Fame Super Red

Re: Lost security pasword CUCM 5

Hi Sergio,

This is from fellow NetPros Mahesh and Ken :)

Recovering the Administrator Password (look towards the end of the procedure and you will see the option for the Security Password as well :)

If you lose the Administrator password and cannot access the system, use the following procedure to reset the Administrator password.

--------------------------------------------------------------------------------

Note During this procedure, you will be required to remove and then insert a valid CD or DVD in the disk drive to prove that you have physical access to the system.

--------------------------------------------------------------------------------

Procedure

--------------------------------------------------------------------------------

Step 1 Log in to the system with the following username and password:

Username: pwrecovery

Password: pwreset

The Welcome to admin password reset window displays.

Step 2 Press any key to continue.

Step 3 If you have a CD or DVD in the disk drive, remove it now.

Step 4 Press any key to continue.

The system tests to ensure that you have removed the CD or DVD from the disk drive.

Step 5 Insert a valid CD or DVD into the disk drive.

The system tests to ensure that you have inserted the disk.

Step 6 After the system verifies that you have inserted the disk, you get prompted to enter a new Administrator password.

When you get to this step you will get an option to Change either the administrator password or the ***security password***.

--------------------------------------------------------------------------------

Note The system resets the Administrator username to admin. If you want to set up a different Administrator username and password, use the CLI command set password. For more information, see Appendix A, "Command Line Interface."

--------------------------------------------------------------------------------

Step 7 Reenter the new password.

The system checks the new password for strength. If the password does not contain enough different characters, you get prompted to enter a new password.

Step 8 After the system verifies the strength of the new password, the password gets reset, and you get prompted to press any key to exit the password reset utility.

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_callmg/5_0/iptp_adm/504/iptpch2.htm#wp1040303

Hope this helps!

Rob

184
Views
15
Helpful
1
Replies