I just confiured my first CUCM7, I have my gateway setup (2621 with 2FXS and 2FXO). I am using MGCP, now I would like to use my IP phone to make a call, say my cell phone for testing purposes. On my gateway I have an RJ11 line going into my phone jack to 1/0/0 (FXO). How to I configure CUCM7 to allow me to make an outside the network call?
There is a good bit you will need to do on CUCM side. You will want to configure dial plan, add the gateway as MGCP gateway, create route patterns, route lists, route groups, etc. Best place for you to start probably is to review the admin and maintain and operate guides for cisco CUCM on cisco.com.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...