Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Mapping a line to a button in CME

How would I go about mapping a line to a button in CME? I want to make sure that when I user presses a button they get a specific line.

Thanks in advance for the help,

Steve

4 REPLIES
VIP Super Bronze

Re: Mapping a line to a button in CME

Hi,

This is called speed dials...The steps below shows how to configure it

SUMMARY STEPS

1. enable

2. configure terminal

3. ephone phone-tag

4. speed-dial speed-tag digit-string [label label-text]

eg...

conf t

ephone 5

speed-dial 1 4000 Bob

From this doc..

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmespeed.html

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Community Member

Re: Mapping a line to a button in CME

I should've said trunk, not line. I want calls to be able to go out of a specific trunk when the user presses a button on their phone, like a key system.

Thanks,

Steve

Community Member

Re: Mapping a line to a button in CME

Hi,

this is the config that will put an fxo on a button. this is for a door phone but the same if a CO trunk was used.

voice-port 0/1/3

connection plar-opx 299

Station-Id name Door

dial-peer voice 6 pots

destination-pattern 81

port 0/1/3

ephone-dn 48

number 299

name Door

trunk 81

ephone 6

Type 7970

button 1:25 2:48

Community Member

Re: Mapping a line to a button in CME

Thanks,

That's exactly what I was looking for. I was misisng the "trunk XX" command.

Steve

164
Views
5
Helpful
4
Replies
CreatePlease to create content