External phone number mask is irrelevant here as that only applies to call made outside of the system, i.e. PSTN.
You would need to build Calling and Called Transformation patterns if you really need this, however I would not recommend that as there is a reason you went to 7 digit dial plan. If 4 digits is still permitted yet 7 digit works why is it a problem to display the 7 digit number?
I should not display the 7 digits number because the end user confuse, the project says that i need to update all directory numbers (Extensions) from 4 to 7 digits, and for the end user this will be transparent and they continue using 4 digits for communicate internally.
The only problem that now i have is that when an user calls to another user in the display of phone shows the 7 digits and i need show only the usual 4 digits..
I test Called Party Transformation Pattern and Calling Party Transformation but the system don't allow insert 2010 or
3602010 respectively because 3602010 is a DN and 2010 is a Translation Pattern, i test deleting the translation pattern but the call not complete and return the error: "Your call cannot be completed as dialed, please consult ......."
Is something wrong.. please any comment will be grateful.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...