In the phones in question, setup the CSS such that they match a partition P2 for placing outbound calls. P2 should have route patterns for (local, LD, intl etc or 9.@) with calling party restriction set to Restricted. This will cause callmanager to send the call signalling with presentation bit set to restricted. For the remaining phones, setup the CSS with partition P1 for placing outbound calls. P1 should have calling party restrictions set to Default.
Thanks for your help. Actualy I was thinking that it might be another approach to do it.
As far I know I don't think this would be easy for a select number of users. If it was
for a business unit or location I think we could do it with CLID restrictions on the route patterns. But again this wouldn't be easy to manage for select users, much easier if it was for all users in a OpCo.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...