Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Match DSP Calculator Configuration with CCME

Hello everybody...

I`m already configuring a CCME 2801 and I`ve had troubles to match the DSP Calculator Configuration with my router configuration. I have a troubles with the association of dspfarm profile for mtp and conferencing. They shows all the time a "registered status" but never active. The only dspfarm profile Working (active) is the dspfarm profile for transcode.

The issue here is that i never see the dspfarm working for conferencing and mtp.

This is the DSP Calculator Configuration:

sccp local <local interface>

sccp ccm <call manager IP address> identifier <ccm ID #> version <version #>

sccp

!

sccp ccm group 999

bind interface <local interface>

associate cme <cme ID #> priority 1

associate profile <conferencing profile ID #> register <conference bridge name>

associate profile <transcoding profile ID #> register <transcoder name>

!

dspfarm profile <transcoding profile ID #> mtp

maximum sessions hardware 2

associate application SCCP

dspfarm profile <transcoding profile ID #> transcode

maximum sessions 2

associate application SCCP

dspfarm profile <conferencing profile ID #> conference

maximum sessions 6

associate application SCCP

I`m already using on board PVDM.

Any suggestion?

Thanks in advance.

1 REPLY
New Member

Re: Match DSP Calculator Configuration with CCME

I have same question.

HD-2V need to be similar to the Card? Onboard the PVDM not?

302
Views
0
Helpful
1
Replies