Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Max Call Duration for Overhead PA calls

CCM 4.2 Sets = 7900

Does call manager have an option or setting to control the duration of a call.

We have a joker on site who is queuing up the PA amp via CCM phone then walking away, leaving the hanset off.

From the phone we dial a code <*555> that hits a route pattern that hits a router then a PA interface and then the PA amp.

we would like to make this call a max duration of 30 seconds. any ideas?

Many Thanks

2 REPLIES
Cisco Employee

Re: Max Call Duration for Overhead PA calls

Hi!

What about using the following?

This command will make the port to remain connected for 30 seconds after no voice activity is detected by the voice port:

voice-port 1/0/1

timeouts teardown lmr 30

Refer to:

http://www.cisco.com/en/US/docs/ios/voice/command/reference/vr_t2.html#wp1641006

Regards,

Teresa.

If it hopes please rate! :)

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Re: Max Call Duration for Overhead PA calls

Thanks Teresa -

I figured if it could be done it would be done at the port level. But what if there is a lot off backround noise, this would count as voice thus activity?

Also this port a FXS on a 2600 router.

Thanks again

216
Views
0
Helpful
2
Replies
CreatePlease to create content