Hi - My take on this is that "node" refers to each CUCM running CTI Manager in the cluster:
From CUCM 4.system guide:
Maximum Devices Per Node-This parameter specifies the maximum number of devices that all CTI applications can open on any CTIManager node in the Cisco Unified CallManager system. The default specifies 800 devices
I would also bear in mind busy hour call attempts (BHCA)and server device weights in defining CTI resources:
MCS 7845 will take a Max device weight of 10000
CTI Ports / RPs with BHCA of < 24 will each have a weight of 8
In this case the max CTI Ports / RPs that should be defined on this server is 1250.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...