I did a test on Dialed Number Analyzer by keying more than 24 digits,it give the error message "Dialed Digits should not have more than 24 digits" .This test is tell that CCM can only process no more than 24 digits.
Indeed,i am looking for specification that specifically stated this.
Hmmm. I haven't come across such spec. If I have, it didn't stick in memory where I might find it again.
Maybe someone else has come across something.
I just wanted to point out the "obvious" that your question is an easy one to test yourself and you have done that. But I do understand that maybe someone wants to see some official documents and that's why you are looking for the spec.
Maybe thumbing through the IPT Troubleshooting book (bible) would have max dial plan digits mentioned somewhere?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...