I am having a weird issue here. No matter how to loop my ephone-dns or voice hunt-group or etc. The call will ring out after 1 minute 30 seconds. I do not wish to failover the call to voicemail at the moment. Any ideas?
Router#sh run | s ephone-dn 1
ephone-dn 1 dual-line
number 1501 secondary 62601501
call-forward noan 1502 timeout 300
voice hunt-group 1 sequential
list 2000,3000 \\*** all phones has dn 2000 and 3000 to ring them accordinly
I am not sure about the exact requirement, but if you want to forward call to voicemail after hunting, the max hunting time is controlled by "timeout xx" parameter in voice hunt configuration. If all endpoints are SCCP, I prefer to use ephone hunt since it gives more tuning options.
Thanks for the reply, however the call flow that I want to achieve is to loop the call for eternity and not failover to voicemail at all. I want the call to keep ringing until someone answers the call.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.