How can configure it to alert administrator and off-net system automatically.
The MCID request is sent as a ISDN Q931 facility message and the exchange sends back an acknowledgement about the success of the trace request. The network then uses their internal systems to run the trace.
The reason I am asking this question is that CIPT 4.1 page 460 indicated the following. It says notify the on-net personnel and offnet system. Understand now that off-net is just Q931 facility message, how abou ton-net? THanks
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...