We have procured MCS 7845 I3 for fax server installation. Installed OS and found working fine. But recently we had an HW Audit in which they have removed the HDD while it was running to check whether RAID is working or not. From then, I am getting this error " Pxe-e61:media test failure. check cable Pxe-m0f:exiting broadcom pxe rom" and not able to boot. Kindly suggest me the next step and any solution if available.
Righ now I have the same problem with a MCS7825I2...I maked an upgrade from CUCM 5.1.2-1000 to 5.1.3-7000 and then switch version un Publisher , but when the server is booting...says this error...Pxe-e61:media test failure. check cable Pxe-m0f:exiting broadcom pxe rom...
The suscriber its up, with version 5.1.2-1000, but I don´t have DBase backup....Can I backup DB from the suscriber to a sftp server?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...