Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MediaList Exhausted

Good morning,

I received the following alert below this morning, RTMT still states that it is in safe range but I just wanted to know if there is anything that can be done to mitigate the situation:

Number of MediaListExhausted events exceeds 0 within 60 minutes.

The alert is generated on Thu Jan 12 08:00:06 EST 2012 on cluster StandAloneCluster.

There are 2 MediaListExhausted events (up to 30) received during the monitoring interval From Thu Jan 12 07:38:06 EST 2012 to Thu Jan 12 08:38:06 EST 2012:

MediaResourceListExhausted Originated from CallManager
MediaResourceListName : MRGL01-xo-for54-agents
MediaResourceType : MediaTerminationPoint
NodeID : icmcucmsub4


MediaResourceListExhausted Originated from CallManager
MediaResourceListName : MRGL01-xo-for54-agents
MediaResourceType : MediaTerminationPoint
NodeID : icmcucmsub4

3 REPLIES

MediaList Exhausted

Hello Jason

Medialist exhausted means that CUCM has gone through all the devices  in the Media Resource Group and was not able to assign a device to use. You can do this , Log in to RTMT , click on the Alert Menu> Set alert  Properties > Select the  alerts you are getting and uncheck the Enable Alert box or selecting the alert type MediaListExhausted andchoose  next, then you will be able to configure a Threshold to trigger the  alert only when the number of MediaListExhausted events exceed a certain  number within an hour. This will reduce the number of alerts of this type.

If you want too take a look on CUCM RTMT documentation, in Alert section.

Rate this if helps you

Thanks

Leonardo

New Member

MediaList Exhausted

What is a safe number for the threshold to be configured to, it was currently set at 0 times within the last 60 minutes?

Re: MediaList Exhausted

40 minutes, but take will decrease the alerts.

https://supportforums.cisco.com/docs/DOC-4108

Ajust thee time according your need

5857
Views
10
Helpful
3
Replies
CreatePlease to create content