Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Meet-Me Conference Bridge - CCM 4.1

How can an administrator disconnect a caller from a bridge? Can the administrator view what phones are attached to a meet-me conference? We have a meet-me conference bridge that is stuck in the "open" position. What can be done to disconnect attendees or reset the bridge so all connected calls are disconnect.

3 REPLIES

Re: Meet-Me Conference Bridge - CCM 4.1

You can try reset the conference bridge from CM admin page and see if that helps. Or best bet is to restart IP Voice media stream service.

New Member

Re: Meet-Me Conference Bridge - CCM 4.1

Thank you for your response. Resetting the bridge has helped but the problem seems to happen way to often. How do you restart the IP Voice Media Stream Service? I found the service page but the only options are to Update, Set to Default or Advanced. thanks again.

New Member

Re: Meet-Me Conference Bridge - CCM 4.1

Hi Birni,

I have almost the same issue as you have had and I would like to know the following:

Do you know how to reset a specific meet-me that are running in the system?.

i.e: we have 10 meet-me running at an specific period of the day and for any reason, we need to reset a specific one of them. How can we reset this specific meet-me without reset others?.

Thanks,

Marcelo

688
Views
0
Helpful
3
Replies