Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Meet me problems - i get busy tone

Hi, i have a problem with a closter of 4 CM 4.1 3 , when i try to start a meet me conference i receive busy tone (this only hapens when i?m register on one of the 4 CM)

1 REPLY
Silver

Re: Meet me problems - i get busy tone

If the Meet-me Conference fails with a reorder tone, perform these steps:

If this procedure is followed to initiate a Meet-me Conference, or someone joins a Meet-me Conference by dialing the Meet-me Conference number and the call fails with a reorder tone, check if the Meet-me directory number belongs to any partition.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009476a.shtml

If the Meet-me directory number belongs to a partition, verify that the IP phone's calling search space (the IP phone that initiates or joins the Meet-me Conference) includes the partition where the Meet-me directory number is assigned.

245
Views
0
Helpful
1
Replies