Thanks for the reply to my earlier message. Guys I am having problem with Meet Me conference. I am using 7936 ip phone. Upto two persons can use Meetme number to conference. As soon as the third person dial to conference in he gets a busy tone signal. Now if I replace the IP Phone 7936 with 7940, then more persons can conference in using the Meet Me number. No sure what is wrong. Any ideas. FYI conference bridge is also configured.
This sounds a little too weird to me. Number of Meet-me participants depends on the maximum meet-me numbers configured along with the number of conference resouces available. Can you confirm if the users are actually dialing the Meet-me number which does not overlap with the DN of these phones. Meet-Me number should not overlap with any existing DN in the network
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.