Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

meetingplace 5.4 video

Folks,

We have polycom webcams(no vtadvantage) and would like to configure meetingplace in a way that we can conference internal participants and external participants in a video conference. We are using a Gatekeep for the end points to register with the mcu. Is there any way we can do this, cisco doc talks about placing the video peience in the dmz and doing it that way, but my question is where will the GK go and how would internal end points talk to external end points???

I will surely rate this post.

  • IP Telephony
1 REPLY
New Member

Re: meetingplace 5.4 video

The gatekeeper will be placed between the endpoints and the MCU. You can find the complete network setup in the following document:

http://www.cisco.com/en/US/products/sw/ps5664/ps5669/products_administration_guide_chapter09186a00806efd46.html

91
Views
0
Helpful
1
Replies
This widget could not be displayed.