Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

MeetingPlace 8 Auto Attend Feature

Hello

I have enabled Auto Attend feature for my user.

I can see the User Profile has the 'Main Number' field with 6983 which matches the extension

I schedule a meeting from Web Interface

I call meetingplace using endpoint 6983

I'm still presented with :

press 1 if you know the meeting ID

press 2 if you want to start a meeting

press 3 to access your profile

if I press 1 and enter the meeting details, and I check the Meeting Invitees from the Web Interface it shows up as Guest.

I must be missing a checkbox somewhere or am I not understanding this feature?

Regards

Felix

  • IP Telephony
Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

MeetingPlace 8 Auto Attend Feature

Hi Felix,

Could you please check the below parameters are configured?

-Meeting profile match the main phone number

-Auto attend mode set to "automatically join meeting

-Allow any profiled user to initiate set to "yes".

Regards,

Tere.

If you find this post helpful, please rate!

Regards, Tere. If you find this post helpful, please rate! :)
3 REPLIES
Cisco Employee

MeetingPlace 8 Auto Attend Feature

Hi Felix,

Could you please check the below parameters are configured?

-Meeting profile match the main phone number

-Auto attend mode set to "automatically join meeting

-Allow any profiled user to initiate set to "yes".

Regards,

Tere.

If you find this post helpful, please rate!

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Re: MeetingPlace 8 Auto Attend Feature

Hi Tere,

Thank you. After checking your suggestions I found out that the main issue is with this particular user.

What I notice is that sometimes the Main Number field in his profile is 'Blank'

However when I checked in CUCM the number is there!

I have to perform a full sync again from Directory Service page.

Do you know what could be the cause?

Regards

Felix

New Member

Re: MeetingPlace 8 Auto Attend Feature

Nevermind I found the DDTS:

CSCti48222

Which should be resolved in 8.0.2

289
Views
0
Helpful
3
Replies