Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MeetingPlace 8 - DTMF not passed on External Calls

Hello,

MP8 with CUCM8.6

Cisco 9951 IP Phones

MGCP Gateways

Scenario:

Audio meeting in-session.

uses TUI to initiate a call out to invite overseas participant

dials the number, and the call goes through. Then there is an IVR prompt asking for an auth. code to connect the call.

Fails at inputting code. which means DTMF is not being recognized or relayed.

If dialing from the 9951 Phone straight/normally this works.

SIP Trunk is set to "No Preference" for DTMF signalling, and MTP Required is Unchecked.

reading the doc on the SIP Trunk, and CUCM 8.6, MTP will be automatically assigned in this situation to translate/relay the DTMF.

But it is still not working.

I did try MTP required Checked on the SIPTrunk and it doesn't work.

Is there anything to set on the Gateway?

Is it a IP Phone 9951 setting?

Please help

Regards

Felix

Everyone's tags (5)
2 REPLIES
VIP Super Bronze

MeetingPlace 8 - DTMF not passed on External Calls

Hi Felix,

Does this describe your call scenario

pstn-----mgcpgw------cucm---siptrunk--MP

are you dialling into MP from outside? What do you mean by 9951 works if you dial straight.

Can you do a test call and enable the ff debug on the gateway..

debug voip rtp session named-event

pls also send a sh run of your mgcp gateway

Please rate all useful posts

"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

MeetingPlace 8 - DTMF not passed on External Calls

Hello aokanlawon

call flow:              >>                         >>                                 >>

9951 IP Phone -------SIPtrunk----MP----SIPtrunk---CUCM-----MGCPGW-------PSTN

The audio meeting is initiated from inside.

User then does #3,1 using the TUI to call external party (overseas participant) the number being dialed includes some telco IDD code which prompts the user like an IVR before connecting them to the participant.

What I mean by dialling from 9951 works straight is:

from within the company on the 9951 IP Phone, the user dials the same number to connect the overseas participant, and goes through the prompts etc to get connected.

I will need some time to get the logs since customer is overseas.

Thanks

595
Views
0
Helpful
2
Replies
CreatePlease login to create content