Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MeetingPlace call failure (busy tone)


Recently I Have installed Cisco Unified MeetingPlace (on an IBM 3650 server) with CCM 7.I Have done the integration with CCM via Sip Trunk Profile and Sip Trunk.

I have configured the SIP from the MP side following the documentation.

But when i call the meetingPlace number (i have configured a route pattern to MP in ccm which poins to the Sip trunk) I hear busy tone!

I cheked some debug on MP and found that the call reach MP, then it's disconnected. SO i suppose that the problem is from the MP side but i don't know what is exactly.

I have followed the troubleshooting Guide and found that when i go to the media Server Administration, i don't find any MCU! Is this normal. Following the troubleshooting Guide, i have to find an mcu and it's status like this :



Can any networker help me please?


New Member

Re: MeetingPlace call failure (busy tone)

you'll have to add mcu and tie it to app server

New Member

Re: MeetingPlace call failure (busy tone)

Hi, Thx for your help.

Can you please tell me more? Do you mean that I have to add a hardware MCU ? or ..?

MeetingPlace Express work without MCU. IS it different from MeetingPlace?