I added MPE IP Phone service to phones on CCM4.1 initially, and the phone services worked fine.
I changed the integration to CCM5.1.1, added phone service to IP Phones on 5.1.1 and service doesn't work completely.
When you select MeetingPlace service authentications is fine, and the option menu comes back to the phone OK. If you select (for example) join a meeting with ID, you get a message back "You have been idle too long and your session has timed out. Exit the application and try again"
As far as I can tell there is no mismatch in product versions, and in all other respects MPE works fine. User locales are correct. It is just the IP Phone service that is not working.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...