Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MeetMe Drop

Hi guys,

I want change something about MeetMe, for example, I host a meeting use MeetMe 5151, then someone dial in the meeting, when we finished, I press "End Call", I hope everyone drop. I know the default setting is if someone forget hung up , the MeetMe resource will keep always. How can I do ? My ccm is 5.0.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: MeetMe Drop

Hi,

A meet me conference, unlike an ad-hoc conference stays up until there is at least 1 participant in the meet-me conference. The meet-me conference should not drop when one person leaves the conference. It drops only after all the participants have left the conference.

Check the following doc for conferences

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009476a.shtml

HTH

Regards

Nitesh

PS:Pl rate helpful posts

2 REPLIES
Silver

Re: MeetMe Drop

Hi,

A meet me conference, unlike an ad-hoc conference stays up until there is at least 1 participant in the meet-me conference. The meet-me conference should not drop when one person leaves the conference. It drops only after all the participants have left the conference.

Check the following doc for conferences

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009476a.shtml

HTH

Regards

Nitesh

PS:Pl rate helpful posts

New Member

Re: MeetMe Drop

Hi,

Thanks for your reply, I hope you are right. I have to give up testing .

293
Views
0
Helpful
2
Replies