Is there an easy way to merge two different clusters into one? One cluster running version 8.6 and the other is running version 7.1, the new cluster will be running version 9.1 and will be on s different ip scheme than the two old clusters. The export/import method doesn't seem to work very well as there's errors on the imports so I'm hoping there's a good tool out there that someones used to do this? Or another method that will be easier?
There is no direct way to merger a cluster. You will need to do some due diligence. Take your data from both clusters, work through them ie purge, fine tune etc and the use BAT to import data to the new cluster. There are no tools or a magic way to go about it. You can reduce your work load, by upgrading your 8.6 cluster to 9.1...or upgrade the bigger cluster and then manually import data for the second cluster
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...