Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Message in log files when all PRI channels are consumed?

Is there a specific message/string/tell-tale in the CUCM log files for when an attempt is made to set up a call on a PRI but all channels are already full?

In CUCM 5.x, the string to look for is "Locations_updateLocationTblEntry_RELEASE_BANDWIDTH" followed by "Dest no bw to release".

However, on CUCM 6.x, those strings are not found so I believe that they've been changed from 5.x. Would someone please let me know what strings I should be looking for on CUCM 6.x to confirm and/or refute if my PRI was full?

Thanks very much,

1 REPLY

Re: Message in log files when all PRI channels are consumed?

One easy way to see this is to look at disconnect causes.

If you see cause=34, this is 'no circuit/channel available'. This will be the disconnect cause for a PRI that was full. You should be able to search on this string.

-nick

170
Views
0
Helpful
1
Replies