Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

MGCP and H323 FXO disconnect

I am experiencing an FXO disconnect problem when i configure the gateway as MGCP but the problem disappears when i configure the same gateway for H323. I have tried recording the disconnect tones, configured cadence, frequency, tried using our region cptone but to avail. Infact our region cptone works for h323. Am thinking maybe the MGCP call control is not detecting supervisory disconnect at all. Is there some special settings i can set in the callmanager service or somewhere else for MGCP to work ? Is there a difference between MGCP and H323 FXO disconnect problem? I have CCM 5.1.2 and 2801 with IOS 12.4T.

Regards

1 REPLY
Bronze

Re: MGCP and H323 FXO disconnect

check this bug details:CSCdu84171,CSCdu84215

138
Views
0
Helpful
1
Replies
CreatePlease to create content