Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

MGCP associated to (2) Clusters

Im pretty sure it's not possible, but I want to have a failback MGCP registration to another cluster if possible. I have an odd setup where

Cluster A VG A MGCP

Cluster B VG B MGCP

Is there a way in IOS to configure a failback to each other cluster or would this confuse the heck out of the VGs?

Between my clusters (at the same location.. odd I know) will have an ICT.

3 REPLIES
Cisco Employee

Re: MGCP associated to (2) Clusters

AFAIK this is also not possible, not sure how the GW would behave when having connection attempts from 2 different CUCM servers in different clusters for the exact same endpoints. I'm pretty sure this falls under not supported as this has not been tested.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

Re: MGCP associated to (2) Clusters

Go for H.323 if that is really important for you.

You don't want a "funny" config which is not supported (and probably doesn't work) as your "seatbelt".

If you want to stick with MGCP add another gateway and let the provider route the same numbers to all the interfaces of both gateway . Then you really have redundancy.

...and it's supported ;-)

/Martin

Re: MGCP associated to (2) Clusters

Thanks, I was planning on having them route the DIDs to the two gateways anyways. Probably using H323 or MGCP is a horse a piece. AAR will take care of outbound calls if a gateway is down through the ICT.

Thanks!

134
Views
0
Helpful
3
Replies
CreatePlease login to create content