Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP configuration download not working


I have a problem with ccm-manager config command where it says that configuration is successfully downloaded, but configuration attempted stays to 0. As a result I have to manually insert the mgcp commands (e.g mgcp-call agent and redundant host). This output is along with the manual config. If I dont do manual config, there will be no call-agents listed although auto config download was successul.

Any input will be much appreciated.



GW01-2811#show ccm

MGCP Domain Name: GW01-2811

Priority Status Host


Primary Registered

First Backup Backup Ready

Second Backup None

Current active Call Manager:

Backhaul/Redundant link port: 2428

Failover Interval: 30 seconds

Keepalive Interval: 15 seconds

Last keepalive sent: 14:15:06 EST Feb 28 2008 (elapsed time: 00:00:07)

Last MGCP traffic time: 14:15:06 EST Feb 28 2008 (elapsed time: 00:00:07)

Last failover time: 10:08:38 EST Feb 26 2008 from (

Last switchback time: 10:09:08 EST Feb 26 2008 from (

Switchback mode: Graceful

MGCP Fallback mode: Enabled/OFF

Last MGCP Fallback start time: 10:09:11 EST Feb 26 2008

Last MGCP Fallback end time: 10:10:46 EST Feb 26 2008

MGCP Download Tones: Disabled

Configuration Auto-Download Information


No configurations downloaded

Current state: Downloading XML file

Configuration Download statistics:

Download Attempted : 5

Download Successful : 5

Download Failed : 0

Configuration Attempted : 0

Configuration Successful : 0

Configuration Failed(Parsing): 0

Configuration Failed(config) : 0

Last config download command:

FAX mode: cisco

Configuration Error History:


Re: MGCP configuration download not working

Do you have both of the following commands?

ccm-manager config server

ccm-manager config


New Member

Re: MGCP configuration download not working

Yes both of these commands are in there.

Also I have tried inserting them over and over again.

The download attempt keeps on increasing

but configuration attempt stays at ZERO (0)

Thanks for your help

Please let me know if you have clue.