Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MGCP Configuration

Hi,

I was configuring MGCP. Was adding new e1 PRIs. Added 4 PRIs successfully. But when adding 5th and 6th PRIs I am getting one error message. Is this highlighted error due to insufficient dsp rsource?

iec-v-gw-01(config-controller)#controller e1 0/2/0

iec-v-gw-01(config-controller)#pri-group timeslots 1-31 service mgcp

%Please configure network-clock-participate wic 2 first

%Insufficient resources to create pri-group - it has been removed

iec-v-gw-01(config-controller)#framing CRC4

iec-v-gw-01(config-controller)#linecode hdb3

iec-v-gw-01(config-controller)#clock source line

Regards,

Fawaz

2 REPLIES
Hall of Fame Super Silver

MGCP Configuration

Fawaz,

2 things:

First ensure you define the wic with network-clock participate, i.e.

network-clock-participate wic 2

then, ensure you have sufficient DSPs, you can post your current conifig along with "sh inventory" for validation, and use the dsp calulator:

http://www.cisco.com/cgi-bin/Support/DSP/dsp-calc.pl

HTH,pleae rate all useful posts!

Chris

New Member

MGCP Configuration

Thanks chris. It worked.

261
Views
5
Helpful
2
Replies