i'm trying to configure an E1 link to simulate an operator.So I built an E1 cross cable, plug the to edge in the 2 ports of me VWIC2-MFT-T1-E1.The level 1 is ok (green LED), but I got the message BAD FRAME() on the console.Of course the card type is set to E1,the network-clock participate also and the switch type is NET5.
On the MGCP configuration I got the both E1 well registered, one is Network side with clock internal and one is user side with clock external. I've also set the Protocol type to PRI QSIG E1, but still have the BAD FRAME () error message.
The error message even appears without any call, just in ter mon !!
Do you know if it is possible to make such a conf? Do I need to do it in H323 ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.