Re: MGCP E1 Configuration Difference between PRI T1
the main difference is just the channels, since this is not H323 you're not going to define the dial-peers which would need port x/x/:15 but other than that they will be the same. also the basic config of the controller regarding the framing, etc but the telco usually tells you the values you need to set to match their end. also the isdn-switchtype will be provided by the telco depending on what they have, a quick call to the telco will give you all the info regarding what you need to set on your end to work with their equipment
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...