Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
tka
New Member

MGCP endpoint registration rejected

Hello,

I have rejected MGCP endpoint registration. (Status Column in the CCM 5.0 : REJECTED)

What could be the possible causes?

best regards,

3 REPLIES
New Member

Re: MGCP endpoint registration rejected

Check the Domain name, It should be same as Router Host name, or you may change the Host name of the router (MGCP Gateway) & delete old one in call manager & reregister again.

HTH

Silver

Re: MGCP endpoint registration rejected

Set "debug mgcp packets" on the GW and check what the response is when the GW tries to register

200 all good

500 - Name being sent by the GW is incorrect

Check if  IP Domian name xxxxx is set on the GW is so, this needs to be added to the GW Host name in CCM

GW1#

IP domain name CISCO.COM

So the GW name in CCM must be GW1.CISCO.COM

if ip domain name is not set then confirm what the Host name is in both CCM and GW

New Member

Re: MGCP endpoint registration rejected

Dial-peer voice xxxx pots

port x/x/x

service MGCPAPP

The trick is that voice gw do not check service name for existence, so if u misspelled it - nothing will work

4684
Views
6
Helpful
3
Replies
CreatePlease to create content