MGCP fxr-package

[Gordon Ross]

What exactly does mgcp fxr-package do on an MGCP gateway?

I've seen mention that it's needed when using T.38, but we're not using T.38 for faxes.

Thanks,

GTG

[George Thomas]

Yes, FXR package is used for T38 fax negotitation. If you are not using T38 capabilities, its not required.

Please rate useful posts.

[islam.kamal]

Hi

The configuration for a GW that does T38 , you can use FXR as the below:-

no ccm-manager fax protocol cisco              

no mgcp fax t38 inhibit 

mgcp package-capability fxr-package

mgcp default-package fxr-package

mgcp fax t38 nsf 000000

no mgcp fax t38 ecm

Please find the below link:-

http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_example09186a0080bf23f2.shtml

Thank you

please rate all useful information

[Gordon Ross]

Thanks, but I actually want the opposite: I do NOT want to use T.38.

GTG

Please rate all helpful posts.

[islam.kamal]

Hi

This is up to you , if you need to use passthrough. This will be better as the below:-

no ccm-manager fax protocol cisco                             

mgcp modem passthrough voip mode nse

mgcp modem passthrough voip codec g711ulaw

Thank you

please rate alluseful information

[islam.kamal]

Hi

FYI , please also find the below:-

Configuring T 38 for MGCP gateway

mgcp fax t38 ecm

mgcp fax t38 gateway force

no mgcp fax t38 inhibit

Configuring Fax passthrough for MGCP gateway

mgcp modem passthrough voip mode nse

no ccm-manager fax protocol cisco

Configuring Fax relay for MGCP gateway

mgcp fax t38 inhibit

no mgcp fax t38 gateway force

ccm-manager fax protocol cisco

Thank you

please rate all useful information