Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP gateway in SRST mode, incoming calls not routing.

Hi

I have an MGCP gateway (1861) with SRST configured for WAN failure. There is BRI line connected to it and has a number 3709 3416. The extension numbers in the building are 8XXX (around 13 telephones).

in MGCP mode I have a translation pattern to translate the incmoning calls to 8XXX extensions and all works fine. during WAN failure (simulated) 1861 goes in SRST mode and 8 phones register to it randomly. during this, the incoming calls dont work. outgoing are fine. I have dial peer configured and translation rule for incoming also,

Can anyone help with the troubleshooting?

Here is SRST and dial peer confing

voice translation-rule 1
rule 1 /37093416/ /8904/
!
!
voice translation-profile SRST
translate called 1
!
!
voice-card 0
!
!
application
global
  service alternate default
!
dial-peer voice 1 pots
translation-profile incoming SRST
destination-pattern 0T
incoming called-number .
port 0/1/0

call-manager-fallback
secondary-dialtone 0
max-conferences 8 gain -6
transfer-system full-consult
ip source-address 192.168.0.218 port 2000
max-ephones 8
max-dn 14 dual-line
translation-profile incoming SRST
time-format 24
!

Any help is appreciated

Thanks and Regards

Shruti

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: MGCP gateway in SRST mode, incoming calls not routing.

try to modify your pots dialpeer as follows

dialpeer voice 22 pots

incoming called-number .

translation-profile incoming SRST

direct-inward-dial 

and remove the profile from the call-manager-fallback. Test it out.

if this helpful, plz rate the post.

cheers

3 REPLIES
New Member

Re: MGCP gateway in SRST mode, incoming calls not routing.

Maybe you should take good cara of the Status of Callmanager MGCP gatway  Cause MGCP will turn to Callmanager For Routing Calls.

And you can

show call-manager-fallback

confi ter

no mgcp

mgcp

to see if can be OK

You should lookup on MGCP troubleshoot fr cisco.com

New Member

Re: MGCP gateway in SRST mode, incoming calls not routing.

Hi

Thanks for the quick reply. but the problem is in SRST mode not in MGCP.

what do you think?

thanks

New Member

Re: MGCP gateway in SRST mode, incoming calls not routing.

try to modify your pots dialpeer as follows

dialpeer voice 22 pots

incoming called-number .

translation-profile incoming SRST

direct-inward-dial 

and remove the profile from the call-manager-fallback. Test it out.

if this helpful, plz rate the post.

cheers

561
Views
0
Helpful
3
Replies