Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mgcp gateway one way audio

Have a 2851 running 12.4.18 spservices.

two pris one used primary for outbound one for inbound. Have intermittent issue with one way audio when ip phone dial out to the pstn. Does not happen all the time and if the person hangs up and calls back will work fine again. Pulling my hair out.

4 REPLIES
Silver

Re: mgcp gateway one way audio

We had a simulare issue, i went trough all cisco docs on this issue and nothing helped, we finally switched to H323 and the problem went away.

What you can do, is to go through this doc:

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml

if it doesnt help, start some debugging on your gateway: debug mgcp packets and the like. try to hold the call you experience one way voice problem with and resume again see if that help. Phone firmware could also lead to such issue.

HTH

Silver

Re: mgcp gateway one way audio

While persistent one way audio is almost always routing or packet delivery issues, we have had a number of cases where occasional one way audio like this has been flaky dsps, or dspware on the router causing issues. A lot of times a router reboot will clear it up for a while, and then it comes back.

Mary Beth

New Member

Re: mgcp gateway one way audio

Ensure you have the following command:-

mgcp bind media source-interface FastEthernet0/0

New Member

Re: mgcp gateway one way audio

yes thats correct.

u need to bind your control and media source to a routable/reachable IP.

If you have loopback interface with an IP which is non routable, you maybe sourcing your mgcp audio via that....and UCM may not be able to return it back.

Its good to explicity define control and media source for mgcp

1153
Views
0
Helpful
4
Replies
CreatePlease login to create content