Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP GW doesn't send CONNECT_ACK

Hi,

I've a CUCM 5.1 with an MGCP GW. This GW makes a QSIG connection on a PABX. In very specific situation, I can see that my GW does not reply to a CONNECT isdn message and does not send a CONNECT_ACK.

Is there a command to force this on the Cisco GW?

Thanks

jp

2 REPLIES
Cisco Employee

Re: MGCP GW doesn't send CONNECT_ACK

An ISDN Q931 connect should always be replied to with a connect ack. What is the 'very specific situation' you refer to that causes this problem ? Do you have a debug isdn q931 log that shows the messages - if so, please paste here.

New Member

Re: MGCP GW doesn't send CONNECT_ACK

Thabks for the answer.

The very sporadic situation is a call to an analog bipper system connected on an analog trunk on the PBX.

It appeared that the problem was a misocnfiguration on the PBX, but of course, as it's not my PBX, I can't have the real cause of the problem.

Anyway, I still don't understand why my GW didn't reply with CONNECT_ACK.

rgds

jp

203
Views
0
Helpful
2
Replies