Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

MGCP GW Registration Failure

Hello Experts,

We are facing problem with the MGCP Gateway from yesterday. It is showig on the gateway side that it isregistered with the call manager, but the endpoints of this gateway is showing unregistered in call manager side. Whenever i re-iniate the MGCP Process by typing

no mgcp

mgcp

then for the some time ( for 1 2 minutes ) , it shows that the MGCP gateway enpoints are registered but after that it becomes unregistered again.

Can someone explain me what is the reason behind ?

Everyone's tags (2)
8 REPLIES
New Member

Re: MGCP GW Registration Failure

Hi i am also having problem in cucm8.6. did you get any solution for this. please post it if you have any workarround.

thanks in advance

regards

SS

Sent from Cisco Technical Support iPhone App

New Member

MGCP GW Registration Failure

Hi i am also having the same issue in cucm8.6.when i added the gateway for minute it was register and after that showing unregistered in CUCM.

Please suggesr....

regds,

Sachin

MGCP GW Registration Failure

Hi,

delete the gateway from CCM. remove the MGCP from the voice gateway, reload the gateway.

after that configure the MGCP gateway and it to the CCM.

I have faced this issue in Call manager 7

HTH

Anas

please rate if it is helpful

MGCP GW Registration Failure

Hi,

kindly find the below thread, it is helpful

https://supportforums.cisco.com/message/3759925#3759925

HTH

Anas

please rate if it is helpful

New Member

MGCP GW Registration Failure

Hi Anas,

Thanks for the help.

I have restarted the CM service on both PUB and SUB after that my problem is resolved.

Also I have observed one thing when i was removing the MGCP call agent,Gw seems to be register but when reset the gateway showing unregister.

Commands:-

no mgcp call-agent

no mgcp

mgcp

So final solution is restart the CM services.

MGCP GW Registration Failure

Hi Sachin,

good for you.

when you do reset from call manager, you need to run "no mgcp" and "mgcp" on the gateway

HTH

Anas

please rate if it is helpful

MGCP GW Registration Failure

It is bad solving such cases by resetting CM whole service

Customers will get annoyed

Regards

Haitham

MGCP GW Registration Failure

due to that i don't recommend MGCP GWs, H323 is more more stable

Anas

1143
Views
0
Helpful
8
Replies
CreatePlease to create content