Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

mgcp h323 sccp at the same time.

I have an isr2821 with EVM (8fxs and 6fxo) and vwic2-2mft-e1.

In my original design I though use MGCP protocol for the e1 and fxo's (with cucm6)

The customer told me the telco only offers e1 cas-r2 for the PSTN. Now I have several questions for you:

1st. e1-cas r2 force to use h.323 protocol.

2nd The recommendations for fxo is use mgcp.

3rd The recommendations for fxs is use sccp.

4th I don't want complicate the config with dial peers.

Its possible to use simultaneously the three protocols in the same 2821 router?.

4 REPLIES
Cisco Employee

Re: mgcp h323 sccp at the same time.

You should not have a problem doing this - we have seen many customers run all three applications on the same device in the past.

New Member

Re: mgcp h323 sccp at the same time.

Thanks Paul. I still have a doubt.

How add the same physical gateway with different protocols if the name must be unique?.

Thanks

Re: mgcp h323 sccp at the same time.

When you add gateway using MGCP, it uses hostname, when using H323 it uses IP addresses.

It is basically like TCP port numbers,

VIP Super Bronze

Re: mgcp h323 sccp at the same time.

HI, just to add one more thing...With sccp, callmanager uses its mac address..

so with MGCP, it uses Hostname,

With H.323 it uses IP address

and with sccp, it uses the gateway's mac addy.

I love cisco! Now tell me which other vendor can give you a multiprotocol solution withing same device!!!! Cisco here we goooooooooooooooooooooooooo!

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
153
Views
15
Helpful
4
Replies
CreatePlease to create content