Router1(mgcp)--E1(cross--(mgcp)Router2--CCM(4.1(3)sr4). Router1 E1 & Router 2's MGCP gateways are registered to CCM. show isdn status display "multiple frame established". controller configuration on both end is pri-group timeslots 1-3,16 service mgcp.
Problem I'm facing here is, when phones behind Router2 calls phone behind Router1, debug isdn q931 on both router shows "no circuit/channel available". I've tried changging B-channel order selection, but same results.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...