MGCP PRI Need it to shut down if losses connection to CUCM
I have two gateways that feed a PBX, all in and outbound traffic from the PBX is feed thru these. I am running MGCP on the gateways. If one of the gateways losses connection to the CUCM cluster, it drops the D channel for a few seconds and comes back up in a local mode.
I need it to drop the D channel and stay down so the PBX will route it out to the other gateway.
The reason for this is if they lose network connection to the office, they still need to get calls in and out.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.