Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

MGCP Protocol using NI1 on cisco router

Hello,

We have configured MGCP Protocol on cisco router using PRI with NI2 switch type and working fine, but for temporarty basis we have to switchover to NI1

Is there possibililty to change the NI2 to NI1 and if yes how could we do that?

Thanks

Regards,

Sam

2 REPLIES
Blue

MGCP Protocol using NI1 on cisco router

Hi Sam,

Are you using MGCP auto config for gateway configuratio or you have manually configured the MGCP gateway.

Regards

Ronak Patel

Rate helpful posts.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
Community Member

MGCP Protocol using NI1 on cisco router

HI Ronak,

We are using MGCP auto configuration, two lines ccm-manager config given and all config fetching from CUCM currently,

We will use two PRI  - So will it possible - one PRI NI1 and another NI2?

1 PRI - CUCM - DMS 100 NI1----------Centeral office Moetel DMS 100 NI1

i.le NI1 to NI1

and other PRI CUCM NI2 --------central office NI2=GTD 5

i.e NI2 to NI2

Thank

Regards,

Sam

348
Views
0
Helpful
2
Replies
CreatePlease to create content