Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP QSIG / MGCP ISDN 30 Configuration

Hi Guys..

I would realy appreciate some help .

I have a 3745 gateways runing QSIG (MGCP) at the moment we have just aquired an ISDN 30 to PSTN i have tried configuring it (MGCP Controlled as well) but it wouldnt work. please what am i doing wrong.. attached is the config..

2 REPLIES
Hall of Fame Super Gold

Re: MGCP QSIG / MGCP ISDN 30 Configuration

To connect to PSTN, you need to configure primary "net5", not QSIG.

Also consider if was to use H.323 instead, you would have more features, less configuration, less bugs.

In any case check "show controllers E1" first.

New Member

Re: MGCP QSIG / MGCP ISDN 30 Configuration

What is not working exactly ?

Check the controller E1 status, and if it's OK, check the ISDN status. Is the Endpoint registered in the CUCM?

You can try to add a dial-peer for this interface, like

dial-peer voice 10 pots

service mgcpapp

port 0/1/0:15

Cheers

186
Views
0
Helpful
2
Replies