Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MGCP Qsig problem

Hello,

I have two problems.

I am using CUCM 7.1.2a , Alcatel 4400 r6 and GW 3845 - c3845-adventerprisek9_ivs-mz.124-11.XW10.bin

Simple scheme:

PSTN ===E1=== Alcatel4400 ===E1 - MGCP Qsig ISO=== CUCM7

1. I make a call from PSTN to CUCM7. When the PSTN side hangs up, I am getting a fast busy tone on a CUCM side and there is still a call time running on display for 30 seconds. So no correct disconnect is made until CUCM side hangs up.

2. When I make a call from CUCM (via Alcatel) to a non-existing number or swithed off cell phone, I won't get a tone or message saying that remote side does not exist as I should.

I am attaching my config and debugs. Any help is really appreciated.

Thanks

Kamil

162
Views
0
Helpful
0
Replies